I ordered two sets of caliper kits this week and they came in in just 3 days.
Now I went to rebuild my calipers and the front kit was too big and the rear kit fit the front perfectly. I checked online with other distributors and found the same wrong part numbers.
Anyone else run into this??
I put the WK532 (listed as rear) kit into the front calipers but now have to find the right rear set to do the back/
ATE kits always work fine. Let me know if I can help.
E.
Eric:
I didn't know you sold them, you should advertise here. I always try to support the site vender's. I already bought from Rock Auto and have to deal with Raybestos now because they cross referenced them to Dorman brakes and come up with the same mis-information - 48mm fronts and 42mm rears.
I used the 42mm rears on my front now have to convince Raybestos that the rears are 33mm.
Anyone have a good spec sheet that I can fax to them?
I have the sheet from my Haynes manual but page doesn't reference year model or car.
Tx
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)