I just bought a set of IDF40 32mm venturi’s and they are not stamped with the size (from a third part vendor).
Are all Weber venturi’s stamped with their size?
They looked machined and are very nice. Are the Weber’s machined or cast?
Mine aren't stamped and they have a spun look to them. Get calipers and measure them.
Where did you buy yours?
From Andy Dunno where he got 'em.
Factory ones are marked...
SOME aftermarket Vents aren't.
Makes no difference. Simply measure and have at it.....
Clayton
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)