preping for the RacerChris rear suspension kit and look at what I found!!!
So hopefully the plan is to
weld the crack,
weld on the ear kit,
and then weld in the inner
and outer console kit.......Good????
that is easy to reweld and not suffer the time and expense of replacement
your a scholar and a gentleman!!
GregD
looks like a stress crack and not a rust issue, so with the Dr. .... weld her up and add the kit, that should work just fine ...
Andy
ok here is the after:
racer chris's ear piece
inner console support
outter console support
I don't think this one is going anywhere!!!
Attached image(s)
here is a shot of the outter and where the wedge piece goes in tying in the whole thing. STill just tacked. I'll show the otherside but the welds are a bit ugly, metal got thin in places from rust in the hell hole area. Planning on fixing that today..
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)