Anyone know if a regular aftermarket tach will work on a 83-84 RX-7 motor?
I was thinking it might work in 6 cyl mode ( 2 rotors, firing 3 times)?
Thx
Mark
that's what I was kinda' thinking.. as long as there is only ONE ground wire to measure spark impulses from.
I had an autometer tach on my RX-7...
Buddy installed it, so I don't know if it was configured for a 4 or 6....but I'm sure the autometer tech site would some useful info....
S.
A rotary tach will work just fine. Any tach for a 4 cylinder will work for a rotary,, so I am sure a rotary tach should work fine with a regular 4 banger.
-Rob
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)