If you don't know where I'm at gimme a shout. 720-480-2540
Why do you guys always do stuff when I can't make it??? ooooohhh.. I get it.
It was a quickie. Too cold to work outside dropping the front driveshaft on the kid's Cherokee, so it's a good day to do some welding in the garage.
Mr. Heater's on!
Wrong side of the Divide!
Muffler's out and on the bench.
Grinder and wire wheel - check
Mig welder and gas in the bottle - check
Ooh... I need a steel scab plate. I might have to walk out back into the snow.
Brant should be here in an hour or so. I had to turn the heater down to low. It was getting warm!
Scab plate ready, muffler ground clean, I'm all set. Danny's coming over too. Ferg, where are ya? Got your voice mail from yesterday.
Ferg can't make it. Brant just called; He'll be here in 30 minutes or so.
When you all are done, swing by my house with a /6 and put it in for me? I have been sick as hell, so all my work must be done from my Lazy-Boy....
See...my wife has been trying to talk me into moving to Denver for a couple years now.......
I wish I could have made it. Family out for Christmas. Next time.
Well... they didn't burn down the house. That's a good thing.
I should have stayed, Riverdale is a great run.
Oh yes, I have a large and twisted sense of humor.....but still only a 1.8 in my engine bay!
Glad to hear it is fixed...wish I could have donned my snowshoes and made it!
did you put the nut on the outer/top/outside bolt? or is it just an optical dilussion?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)