Printable Version of Topic

Posted by: Cevan Mar 21 2008, 01:43 PM

I want to lower the front end of my car about an inch on the passenger side and ¾ of an inch on the driver’s side (driver’s side is already ¼ lower measured using a T-square in a level garage). My A-arms are not close to being parallel to the ground so I think I have some room. I intend to get the car aligned after this procedure.

I went to turn the adjuster screw on the passenger side and it is already turned all the way so that the cap touches the top of the A-arm assembly. I’m assuming that if I want to lower the car further, I need to remove the cap and put it back on a few degrees clockwise of where it is now, and do the opposite for the driver’s side.

If I jack the car up and get the wheel off the ground, will there be tension on the torsion bar as I remove the cap? I just picture the cap going flying once it’s pried off. I searched the forum but couldn’t find an answer to this question.

Posted by: sww914 Mar 21 2008, 01:55 PM

If the car's jacked up there isn't any tension on the cap. Just take the bolt out and pry/wiggle the cap off, move it down 1 spline and put the bolt back in. I try do do a bit of wiggling of the cap rather than just brute force prying so that only the cap comes off instead of pulling the whole torsion bar out.

Posted by: elmonte Mar 21 2008, 01:57 PM

There will be NO tension on the bar if the wheel is off the ground. Moving the adjuster a couple of splines will get you where you want to be


Cheers


Always day late dollar short sww914 said it all

Posted by: Cevan Mar 21 2008, 02:01 PM

Thanks for the reply. I'll try and post some pictures for future reference.

Posted by: Spoke Mar 21 2008, 02:08 PM

If you have a front sway bar it may keep tension on the lifted torsion bar. In this case you would need to disconnect the sway bar at one point or lift both wheels.

Posted by: brant Mar 21 2008, 02:35 PM

don't forget to do another alignment on the car when you get the ride height finalized and where you want it.

Posted by: r_towle Mar 21 2008, 03:04 PM

QUOTE(Cevan @ Mar 21 2008, 03:43 PM)

Posted by: Jeffs9146 Mar 21 2008, 05:30 PM

It is a very simple job and should take you longer to set the car up on Jackstands than to move the cap a few splines!

Posted by: Eric_Shea Mar 21 2008, 05:36 PM

Reindex as everyone mentions... fairly easy once you understand the concept.

Posted by: JPB Mar 22 2008, 07:13 AM

How low does it look?

Posted by: Cevan Mar 22 2008, 07:13 AM

Easy as pie! I figured I post a couple of pictures. As you can see, the torsion bar came out with the cap. Mine came out with almost no effort. The bushing beneath literally crumbled apart. I will make some replacment ones to keep the elements out.

Posted by: Gint Mar 22 2008, 09:05 AM

Those "bushings" are just foam circles as large as the adjuster cap in circumference and about 1/4" thick with a hole in the middle.