Hello all,
Well its been about 4 months since I embarked on building a mandrel bender to make oil lines, and its bending...
Here's the first oil line, I'm going to check it in my car this weekend and send it (or a revision) to my friend with an original 914-6 mount as well as a Patrick Motorsports mount.
These will be zinc plated once they are done. Still unsure on price, I'm going to send out drawings to a mandrel bending company to see what the professionals will charge me to do their magic.
Cheers,
Don Welch
DWDesignWerks.com
Dude...That is awsome! having just gone through a jerry rig job NOW ya tell me about this.....Put an AN fitting on the end and sell me that one!!! JK.....
Looks great Don! Might not be a bad idea to check out exhaust clearance.
thats a good point.....here is a pic of my deal next to his setup looks about right?
I need one or two or...
T.C.
Call me and I'll come over to help you build the mock engine & tranny and get them up in the car. I'll even bring some Casadores Anejo & Coronas.
That looks KILLER! Nice work as always, Don!
That is nice. I might even buy a set myself. Kepp us posted please.
Really great pictures! Is the car in the picture currently completely dry of oil? I didn't see any drips, so it must be out of oil???
Now the side lines to the front cooler please!
Great to hear!
The 6 is still in the air, with the H/E on the floor, waiting to test fit.
Just give me a heads up as to when I should be home to receive it! If I am home when it comes in I can have an answer for you in a few minutes!
Dammit. I recently bought a PMS oil line which goes half way
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)