Hi all,
What I'm looking for is the air box mounting bracket for a 74 2.0L. It is the little metal strip that is bolted to the drivers side intake runner, that the air box clips to. Anybody happen to have an extra kicking around somewhere?
Thanks,
Bump!
Somebody, anybody? Bueller? Bueller? Bueller?
I'm sure somebody's got one kicking around.
I am sure I have one I just have to find it.
I will email you later today when I have it.
CCLINCAMP914
Thanks Craig, I owe you a beer next time I'm in your neck of the woods. (Who knows when that'll be, though)
I know the airbox is different but might the part be the same as on a 1.8?
If so, I'll have it for you...
Hmmm, I have no idea. I've never seen a 1.8 up close and personal. Could you post a picture of it? I might be able to tell if I saw it.
Is this it or is this the bracket for the board? Can't remember, I took the engine out so long ago...
Ooops...
Attached image(s)
Not sure what thats for, but I'm pretty sure it's not what I'm looking for. What I need is a bracket that clamps onto the driver's side intake runners. Then the airbox clamps onto this bracket. Does that make sense? I hope so.
Thanks for checking,
Gotcha... if I had it it probably went with the engine. Sorry.
No worries, I have a feeling Craig will be able to find one. Thanks for checking, though.
Mike Hello I am on my way to CAMP 914 just stopped off for luch and check email.
Eric, the pic shows a bracket which is welded onto the side wall for the relay board.
CCLINCAMP914
Mike here is the part I have.
Attached image(s)
Found a pic! Here is the bracket that I need.
Attached image(s)
Mike If I get up to CAMP tommorrow I will look again.
CCLINCAMP914
Thanks Craig, no rush though. I won't be driving the teener till spring, so next time your out have a look. Don't go out special for me.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)