My new 19mm MC has only one wire connection for the break light...which of the two wires from my wiring harness do I connect?
Thanks, Dave
on a '74, it's referred to as F6, the brake warning switch wire.
brown with a yellow stripe.
seen here.
http://www.pelicanparts.com/914/parts/Electrical/914_electric_74C.jpg
Both wires. You need to take the switch off your old master cylinder. Cars up to 74 have a ballast connected on the hand brake behind the dash. If you need a new one I have 2 left. I believe they are no longer available. $30 shippped Priority Mail.
I don't think you necessarily have to use the old switch. The BROWN wire is just a ground lead. The 19mm switch grounds through the M/C to the chassis.
At least thats what I see on the 73 electrical schematic.
Exactly--just plug the brn/yel wire in, and tape the brn wire out of the way.
--DD
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)