How can I test the turn signal flasher relay to make sure it is ok? My Turn sigs don't light up or flash. Check the relay? How often are turn sig probs due to relay failure? If mine is fried are these available at flaps or go to Pelican?
TIA
Allen
Did you check the fuses first? I had a problem with mine (i would even see the rpm guage jumping around when they were turned on) but then i noticed my fuse had dislodged itselft. 1st reply so i guess i get to state the obvious.
Maybe this will help...
http://www.914world.com/bbs2/index.php?showtopic=72494&hl=
Hope it helps...
My switch was fried. My fault.. I crossed the wires when reconnecting the turn signals.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)