i guess one of these four??
http://www.jegs.com/i/JEGS/555/15730/10002/-1
http://www.jegs.com/i/JEGS/555/15734/10002/-1
http://www.jegs.com/i/JEGS/555/15740/10002/-1
http://www.jegs.com/i/JEGS/555/15729/10002/-1
thanks jim
Attached image(s)
I think that you should be able to thread the end of the accel. cable to screw into the linkage. I found this chart- http://www.hamuniverse.com/antfrac.html
It looks like 3.9mm is very close to 10/32 which I believe is a #10 screw so you could run a die over the cable end and thread it right into the linkage with the #10 threads. You'll need a locknut on that, too.
ok - went to autozone and got me a $23 tap and die set - i tapped the cable end and got it installed semi half assed for now. and for now to me usually means until something breaks.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)