Hey, new guy here.
Could anyone help me identify what intake manifolds I have? the came off of a 2.0 but they look like could go on either a 4 bolt or 3 bolt head. I don't see any casting or part numbers...
Thanks,
Rodger
http://i169.photobucket.com/albums/u227/RStanlow/Stuff/Car%20Stuff/914/Intake006.jpg
They are standard aftermarket type 4 manifolds.
Looks like they may have been drilled out for solex carbs at some point.
Rich
2.0 liter heads have three studs for the intake.
1.8 heads have four.
The difference is in the middle between the intake ports.
So, if you look at your manifolds, you have three holes there, so they will fit either head setup perfect.
Rich
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)