Does anyone know if this master cylinder will fit a 1.8 '74?
http://cgi.ebay.com/ebaymotors/73-PORSCHE-911-T-Master-Cylinder-URO-PARTS- 91135501202_W0QQcmdZViewItemQQcategoryZ33566QQihZ010QQitemZ200229322994QQrdZ1QQs
spagenameZWDVW
thanks
The ad does not say what size MC it is. I am guessing it is 19mm as that was the stock size for 911 or 914-6. This one is probably a China repo of the ATE master cylinder. ATE ones are in the $200 range. Yes, it will fit.
excellent
thanks, gentlemen
I bought two of them ... they should be 19 mm. Look exactly like an ATE with two exceptions .... the reservoir tubing rubbers seem to be a little different and they don't use the washer under the rubbers.
I just pulled theirs' out and replaced them with the ATE setup ... worked fine.
Paid $129 for the first out of Groton and $95 for the second out of a seller in Canada (I think ... both were eBay). They were both drop-shipped from Camarillo, CA. I believe Pelican Parts was considering handling them. Wholesale cost was in the $50 range. Screw ATE.
Check out uroparts.com - their website.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)