Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Bugpack Carb Linkage Ball Studs
Posted by: tornik550 Jul 17 2008, 07:49 AM
I have a bugpack carb linkage. On the end of the linkage there is a large ball stud on each end. Both of mine are very worn. Does anybody know where to get replacement ball studs?
I have looked at all of the local hardware stores and auto stores with no luck. I have contacted bugpack however I am still waiting on a response.
Thanks,
Steve
Posted by: 6freak Jul 17 2008, 09:01 AM
QUOTE(tornik550 @ Jul 17 2008, 06:49 AM) 
I have a bugpack carb linkage. On the end of the linkage there is a large ball stud on each end. Both of mine are very worn. Does anybody know where to get replacement ball studs?
I have looked at all of the local hardware stores and auto stores with no luck. I have contacted bugpack however I am still waiting on a response.
Thanks,
Steve
Use heim joints no drag at all and very good wear factor..stop mess`n with the cheap crap....check Jegs race products good luck
Posted by: rhodyguy Jul 17 2008, 09:11 AM
the other prob is the recieving end/hole on the crossbar. they can wallow out. cb performance might have the ballstud items. the bugpack stuff is usually bundled as complete systems.
k
Posted by: Vacca Rabite Jul 17 2008, 11:21 AM
Did you try McMaster-Carr?
Zach
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)