I just ordered a new set of calipers and rotors for my 72. I went to install today, and the pad springs off the old calipers are too wide. I can see that the old calipers have a wider opening on the top.
Did I get the wrong calipers, or do I just need to order new springs?
Everything else seems to be fine, but I haven't mounted the rotor, or bolted them in yet.
Thanks for the help.
Looking closer, my old calipers have two bleeders and my new ones only have one.
I take it they are the wrong ones?
Wrong ones...
Your year is the crossover year. I'll get started on a set of late model calipers for you.
Put those back in the box and I'll include a shipping label in the box with the new ones.
Thanks. You are a good man.
I guess I better ask, are the rotors the same?
How about the rear calipers and rotors?
Again, thanks.
Rotors are not the same. I have those in stock as well.
Rears are interchangable. No problem there.
OK. I will prep the fronts to be shipped back tomorrow. Thanks again.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)