Posted by: McMark Jul 31 2008, 12:36 PM
It took awhile longer than expected to get everything back from the manufacturers, but they're finally ready to ship out.
If you missed out on the pre-order special, I've decided to extend the $50 discount until the end of next week. These are ready to ship out right now and will only cost $450 if you order a set before 08/08/08!
FreeMotion rears will become available next month. I've redesigned the system and the new design will be much easier to install than the previous iteration. The new ones use the existing tailing arm pivot shaft, which saves quite a bit in manufacturing costs. So the rears will be available at a comfortable $250!
http://www.pmbperformance.com is a reseller for all of these components, so you can add these components to any trailing arm rebuild or caliper rebuild order. Imagine a powdercoated trailing arm, ready to bolt on with a vented rotor, new calipers, FreeMotion bearings, and new wheel bearings.
I also searched up a couple of old threads:
http://www.914world.com/bbs2/index.php?showtopic=41484
http://www.914world.com/bbs2/index.php?showtopic=54639
Posted by: Lavanaut Jul 31 2008, 12:55 PM
Hey Eric, you know that quote I just requested? Well...
Thanks for bringing what looks to be a very high quality part to the market, Mark!
Reid
ps: I'll take a set...PM sent
Posted by: bondo Jul 31 2008, 01:42 PM
QUOTE(McMark @ Jul 31 2008, 11:36 AM)
FreeMotion rears will become available next month. I've redesigned the system and the new design will be much easier to install than the previous iteration. The new ones use the existing tailing arm pivot shaft, which saves quite a bit in manufacturing costs. So the rears will be available at a comfortable $250!
This is most excellent news! I've been most interested in the rears, because I've always thought the rear was less free than the front. (not sure why, but it probably has to do with the front being a strut type)
I bet you're going to sell a lot of the rears... I'll buy a set for sure!
Posted by: neo914-6 Jul 31 2008, 04:02 PM
I did an extensive installation procedure...
Are you going to provide a seal solution aside from o-rings?
Posted by: SirAndy Jul 31 2008, 04:23 PM
QUOTE(McMark @ Jul 31 2008, 10:36 AM)
It took awhile longer than expected to get everything back from the manufacturers, but they're finally ready to ship out.
Dude, will 'ya please fix your signature line so the 3 images wrap around? It's annoying to have to scroll sideways just because of your sig ...
Can i come up tomorrow? I was up until 5am last night and didn't get up until noon.
Anyways, i just need to do some last minute setup changes before the Shootout in Marina ...
I can do that in the parking lot ...
Andy