Anyone know if the temp sensor wire that connects to the sender is still available from Porsche or one of the usual online resources? If so, which one?
Thanks,
Kev
??? there's nothing special about the wire. why not just run an 18 ga wire with solder or crimp on spade connectors? to me, a "temperature sensor wire" sounds like the wire from the taco plate to the connector under the battery.
Nothing special, like Jim said. Just run the wire and plug it into the main harness. It drops off in the console location. If you are using a combo guage in dash, you will have to run an additonal wire up to the dash. Plug into the G on guage. You will need jumpers for the ground and positive.
That's the one, in the engine compartment. Just wanted one with the plastic sheath like the original. Don't have the proper crimp tool for the automotive quality connectors. I know, I'm being anal but I hate chasing electrical problems and hate even worse the poor quality crimp style connectors available locally.
Kev
i don't have a real crimp tool either, just a pair of pliers. i understand the want for the sheathing but you can easily fab a wire.
Get Bowlsby to make one for you. The original has steel tabs on it for securing to the engine.
You can use shrink tubing to make your own sheath.
I have them in stock, in the correct color coding and sheathing. See my website at the link below or email me. You will need to attach your metal brackets from the original wire.
Jeff,
I sent a PM.
Thanks,
Kev
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)