I'm looking for some or all of these four parts for bilstein (not Koni) rear shocks. I need two sets, one for each shock. The most important parts I need are number 9 and 10.
anybody removed bilsteins lately and have these parts they don't need anymore?
Upper ring 914 333 514 01 - number 12 in the picture
Lower ring 914 333 513 01 - number 11
Threaded bushing 914 333 516 00 - number 10
Washer 914 333 515 01 - number 9
I should be able to fix up up.
Someone local has offered me the parts, I need to get them and see if they fit.
I am now concerned, my 914 is having some welding done but it has KYBs. I just got some Bilsteins from mittelmotor and they come with a circlip fitted on the body of the shock, a spring perch, two fat wshers and a top locking nut, does this mean I need lots of little bits? Does anybody have some pictures etc of what I might be missing, I am having bad thoughts about thsi.
Roman
See British rustoration thread
The thick flat washer is specific to bilstein.
You will re-use the upper spring cap and the nut/collar.
You should be all set.
The lower spring perch on KYB is welded in place, so it wont come off.
Rich
Rich, thank you I assume I can leave the circlip in place, put down the lower spring collar, then the spring . Where do the two fat washers go or do I need to disassemble my rear shocks first?
R
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)