Printable Version of Topic

Posted by: mattp Sep 24 2008, 01:47 PM

Can someone send me a pic of a throttle pedal stop?

Posted by: Bartlett 914 Sep 24 2008, 02:10 PM

Here you go.




Attached image(s)

Posted by: mattp Sep 25 2008, 09:46 PM

thanks, can you take it from further out? I need to see where to position it. thanks, matt

Posted by: BMartin914 Sep 26 2008, 08:36 AM

You need to set the "Full Throttle Stop" at Full Throttle travel of the pedal/cable.

It does not have a preset position.

You need to have a helper open the throttle body on the engine to full throttle (with the stop threaded IN) and then move it out to meet the pedal in it's "Full Throttle Position."

Do you have a Haynes manual yet?

Posted by: Bartlett 914 Sep 26 2008, 08:39 AM

That is the stop directly behind the pedal. The threaded plate is a part of the pedal board. The white plastic stop may be missing but the plate must be there. Look behind your accelerator pedal an see if it is there. If it is missing ask on the parts section. Should be plenty around and real cheap.

Posted by: mattp Sep 26 2008, 09:17 AM

i got one, there is no pedal stop at all on my board. i need apic so i can tell where to put this one. matt

Posted by: Bartlett 914 Sep 26 2008, 10:48 AM

QUOTE(mattp @ Sep 26 2008, 09:17 AM)

Posted by: mattp Sep 26 2008, 03:55 PM

there is nothing on the pedal board but I have a used pedal stop i good shape, its the metal base and the plastic bolt. I just need to knowwhere to place the metal base. matt

Posted by: Bartlett 914 Sep 26 2008, 05:46 PM

QUOTE(mattp @ Sep 26 2008, 03:55 PM)

Posted by: Bartlett 914 Sep 27 2008, 01:04 PM

Last one



Attached image(s)