So, I was supposed to repaint a customers car, but I found that the passanger side rear is quite a bit lower than the drivers side. I'd say the tin worm already found it's way into the suspension points.
Also, the 914 looks really out of place in my collection
Attached image(s)
I suppose it can be repaired, but while I'm in there...
Attached image(s)
A 3.6 six would be more entertaining than the 2.0 four...
Attached image(s)
Then with a little rolling of the fenders...
Attached image(s)
Dave good looking set of toys.
By the way, how do you go about attaching a pic to one's response?
Wow, what company makes that red 964? I've been looking for one in a 1/18
maf914,
Thank you.. Over looked it.
Post instructions on stripping the model. I've got two blue models but it would be nice to paint it Olympic Blue.
You could acid dip them in a stainless steel sink
Paul
DOh. Poor quality. I really like the quality of UT models. They are much better than the Maisto's but not as good (and expensive) as the AutoArts.
T
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)