Printable Version of Topic

Posted by: zonedoubt Oct 5 2008, 10:56 PM

I am considering moving the speakers to the stock location. The vinyl on my door panels is ripped in some places and I'd like to get some replacement vinyl. Has anyone been succesful patching in material (pressboard, masonite?) where the speaker holes were and recovering the door panels?

Posted by: SirAndy Oct 5 2008, 11:02 PM

Dr. Evil used to sell brand new backing panels ...

Another thing you might want to look into is repairing the actual door frame. The only way to fit door speakers is to cut into the door subframe ...
Andy

Posted by: southernmost914 Oct 5 2008, 11:26 PM

There very many new products today, go to Home Depot and trace and cut.

Good luck,
Steve

Posted by: tronporsche Oct 6 2008, 12:19 AM

In my 75' doors, after the old board was replaced with new, and then re-vynled by a upholstry guy, I put a 5 1/4 and a 4 1/2 I believe these are the sizes) in the bottom frond corner, i mounted them in by just using machine screws to go into the door metal. They fit perfectly. I then had the upholstry person cut two holes on the INSIDE VYNL PADDING, and board , and I get good sound , but you will need some amplification to push, as there is some muffling. If you want all of the sound , than cut thru the vynl.....but you had better be accurate !!! Than just put some grill covers on. But I like the look of the entire door vynl.

Posted by: brownaar Oct 6 2008, 06:10 AM

I'm looking at the same issue. Here's a link to a member vendor who does replacement door panels using a fiberglass core.
http://www.914world.com/bbs2/index.php?showtopic=7639

Posted by: zonedoubt Oct 6 2008, 01:34 PM

I was looking at those. I think he also sells replacement vinyl. But I'm also considering how to repair the panels myself to save some $$$. They're in good condition other than the hole cut for the speaker.

Posted by: johannes Oct 6 2008, 02:03 PM

If you have an early car with the metal part at the top of the panel, go to home depot and cut a panel yourself.

I had the same problem. I wanted to remove the speakers and repair the ugly panels.
I have the late panels (post 75) and had to find cores in an acceptable shape. Some minor repairs were needed.
If you want to see how to repair panel see my thread in the classics ...
http://www.914world.com/bbs2/index.php?showtopic=54608


.
.

Posted by: r_towle Oct 6 2008, 02:12 PM

Personally I would either find a used set, or buy a piece of masonite from the local store and make a new pair.

If that is not going to happen...
cut a piece of masonite the exact size of the speaker hole and fiberglass it both front and back...sand smooth and lay on new vinyl.

With any repair, cut a new piece of plastic vapor barrier and glue it to the metal door frame before your final install of the new panel.
The vapor barrier will ensure that the new panel does not rot out in two years..
Also, make sure your drains are clean in the bottom of the door...possibly drill a few new ones at the lowest point.

Rich