Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ How to get bearing off of input shaft.
Posted by: fiid Oct 6 2008, 12:01 PM
Hey,
So - I'm trying to get a bearing off the input shaft of the 901.
It's the one that sits behind that nut on the clutch end of the input shaft. I've removed the nut, but I can't get the bearing to break loose and I'm trying to not damage it.
Any suggestions?
Posted by: Mike914 Oct 6 2008, 10:12 PM
QUOTE(fiid @ Oct 6 2008, 11:01 AM) 
Hey,
So - I'm trying to get a bearing off the input shaft of the 901.
It's the one that sits behind that nut on the clutch end of the input shaft. I've removed the nut, but I can't get the bearing to break loose and I'm trying to not damage it.
Any suggestions?
I just raise the whole shaft and let it fall
on a piece of wood a few times till all the little bits scatter to the four corners of the room... 
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)