Anyone have a close-up picture of how the clutch cable is held in place on the pulley bracket? I've found references to a "retaining clip" but have had no luck in finding it or how it attaches.
Thanks
Paul
It's a washer with a tab that folds around the cable bracket and goes into the hole adjacent to the cable notch. I'll see if I have a pic.
http://www.pelicanparts.com/catalog/images/new_images2/914_cable_stop_plate.JPG
per pelican
So, when you install this do you just bend the tab over to fit in the pulley braket?
Thanks
Yes, you bend it around the outside of the housing and then bend it into the little hole for the end of the tab on that washer.
Rich
Thanks guys, one more little piece of the big puzzle done
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)