Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ Opinions please

Posted by: MrKona Nov 16 2008, 02:23 PM

Fellow 914 devotees,

I've been amassing parts for an eventual five-lug conversion. My original plan was to one day flare the car and put bigger brakes on the rear. I picked up Bilstein front strut assemblies, hubs, and brakes with 3.5" spacing.

Plans have changed. I'm sticking with the narrow body. After reading enough opinions on this page, I've decided to go with a 3" set up up front to better balance out stock rear brakes.

I found a local 911 guy who has a '72 911T he is upgrading to Carerra specs. He is in need of 3.5" strut housings and hubs. He has already acquired brakes, and does not need the strut inserts.

So here is the proposed trade: I give him my 3.5" strut housings and hubs (I keep the inserts, use them in the 3" housings). He gives me his 3" housings, hubs, brakes.

I can then sell the 3.5" brakes I keep.

Is this a fair trade? Should any additional money go either way?

Thanks.

Posted by: LarryR Nov 16 2008, 02:43 PM

QUOTE(MrKona @ Nov 16 2008, 12:23 PM) *

Fellow 914 devotees,

I've been amassing parts for an eventual five-lug conversion. My original plan was to one day flare the car and put bigger brakes on the rear. I picked up Bilstein front strut assemblies, hubs, and brakes with 3.5" spacing.

Plans have changed. I'm sticking with the narrow body. After reading enough opinions on this page, I've decided to go with a 3" set up up front to better balance out stock rear brakes.

I found a local 911 guy who has a '72 911T he is upgrading to Carerra specs. He is in need of 3.5" strut housings and hubs. He has already acquired brakes, and does not need the strut inserts.

So here is the proposed trade: I give him my 3.5" strut housings and hubs (I keep the inserts, use them in the 3" housings). He gives me his 3" housings, hubs, brakes.

I can then sell the 3.5" brakes I keep.

Is this a fair trade? Should any additional money go either way?

Thanks.


I would say that your housings are worth a couple hundred more than the 3" housings. I have seen 3" strut housings sell for 100-150. Bisteins in good condition could bring probably sell for around 400. Also, dont count on the inserts to work in the 3" housings.... they might and they might not.

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)