finally found some of them had been previously engraving!
Very nice. What about the proper stamps for them?
are the proper rivets available?
I have not looked at the 914 but if the rivets are the same as the 356 ID plates then the rivets are available.
Rich
Ok, I'll bite...How Much?
Do you have the correct rivets for the plate in the front trunk near the headlight bucket?
This one , along with the door jamb one, should come off for a decent paint job...most I have seen are masked (poorly) and left in place.
Also, when acid dipping, they need to come off or they get destroyed anyways.
Rich
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)