Printable Version of Topic

Posted by: Todd Enlund Nov 23 2008, 11:34 PM

Am I correct in my assumption that this lovely weld bead was added by the DAPO? And that it renders my pedal cluster un-rebuildable?

Posted by: Eric_Shea Nov 23 2008, 11:43 PM

Stick a hacksaw in here and cut it off. It will take about 5 minutes. Then you can get a new shaft and pedal.



I may have a pedal for you but I think my shafts have wallowed holes on the end.

I may have a decent pedal assembly for you if you want it... bronze bushings etc. Needs a paint job.

Posted by: Phoenix 914-6GT Nov 24 2008, 01:21 AM

QUOTE(Eric_Shea @ Nov 23 2008, 09:43 PM)

Stick a hacksaw in here and cut it off. It will take about 5 minutes. Then you can get a new shaft and pedal.



I may have a pedal for you but I think my shafts have wallowed holes on the end.

I may have a decent pedal assembly for you if you want it... bronze bushings etc. Needs a paint job.

Posted by: sixnotfour Nov 24 2008, 01:47 AM

Just grind the weld off. the pin is probably sheered ,the rest is fine.