My brother has a 70 rustobucket in Cathedral City next door to Palm Springs.....I have been given the go ahead to cut it up. Taking orders for parts and stuff..... first asked for first served.... unless YOU actually help.
One lister in Palm Desert has already semi volunteered....
415PB.....contact me....sent you an email....
mike.
i need the front center tunnel acces cover. (no need to cut. just unscrew it please)
lemme know
Will do....
MIke I could use these two sections of the front
trunk seal channel.
Thanks
Garold
For whtever reason I can not post the other pic.
So basically I need the same section for the passenger side also.
Let me know,
Garold
Garold, that section doesn't look too bad. I doubt Mikez donor car has much better. just clean it up and put some new metal in there.
I need parts! Especially, the transitioin between the front of the floor pan to the firewall.
Pedal cluster area, Center tunnel where fuel lines come into fuel tank area.
My rust-or-ation thread....
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=5574
Photos attached.
PM/email me with the gory details of shipping/etc....
Attached image(s)
more photos
Attached image(s)
yet another
Attached image(s)
Yet another. Looks like I'll be doing some
Can't wait for the snow to go and 40degrees...
Attached image(s)
If your still ripping it up I could use the front bumber if its in good shape the dash if its in goodshape plus the starter and the seats. How much are you charging for this stuff.
If you can please email me that would be great. weird_looking_cactus@charter.net
Still waiting to hear from 415PB....he's the lister in Palm Desert.....it's a four hour drive for me to get down there....
Garold/Itsa914,
I'm going to be making some new channel pieces for one of my cars in about a month (when the snow goes, I hope).
Let me know what you need and I'll do some for you while I'm at it.
How is the square brace that runs in the middle of the floor pan from the drivers side over to the passenger side?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)