Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Overbore bearings?
Posted by: jhadler Jan 14 2009, 12:22 PM
Just got a call from my machine shop who is cleaning the case, and polishing the crank for my re-rebuild. They're telling me that the mains are 0.020" over on the OD (but standard on the ID). Is this common? And if so, where the heck do I get bearings to replace them with?
Sounds like this case was bored by the P.O., is it even worth using? Should I be starting over with a fresher case?
-Josh2
Posted by: Todd Enlund Jan 14 2009, 12:26 PM
QUOTE(jhadler @ Jan 14 2009, 10:22 AM) 
Just got a call from my machine shop who is cleaning the case, and polishing the crank for my re-rebuild. They're telling me that the mains are 0.020" over on the OD (but standard on the ID). Is this common? And if so, where the heck do I get bearings to replace them with?
Sounds like this case was bored by the P.O., is it even worth using? Should I be starting over with a fresher case?
-Josh2
Jake has them, part #4020.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)