I refurbished a bus gas tank and used http://www.caswellplating.com/aids/epoxygas.htm. I'm really happy with how it turned out. Unlike the other single part coatings, this dries into a hard coating, which is not surprising because it's epoxy. All of the stories of single part coatings peeling away from the walls of the tank scared me. This stuff will not come off. I had to clean up a few drips from the outside and it took a hammer and chisel to chip it off. I will be using this stuff on any future tank refresh.
Attached image(s)
I just ordered the kit yesterday. Good stuff.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)