So the Racecar/AX weapon should be ready for action once my fuel pump gets here.
I have a good open trailer to haul it around, but since it is an open top car just wondering if anyone made up a cover to keep the drivers area some what dry while hauling the car? Its a race car and I'm really not concerned about it getting wet, but I have a EvoII seat for my fat and it has a fabric cover that can't be removed (easily)and I know I will run in the rain so.... I am looking for ideas mainly to keep the cockpit dry during transport. If I had the extra $$ I would spring for an enclosed trailer but that is not in the budget this year. I was thinking of some sort of a tarp type slip cover????
Here is my racer 914 aka Moby
Attached image(s)
Garold,
I once started to tow my 914 to Marina with the top off. It seldom rains in the summer here so I was not worried about the interior getting wet. But, I noticed that the car was harder to tow. It messes with the aerodynamics having the top off. Much easier with it on.
Now, I should mention that Marina is 100+ miles away. If you aren't going to tow far it probably isn't such an issue.
Here in Ca it rains so seldom during race season that if it's raining on the way to the track you might as well stay home because they won't drive in it. I've had it rain on the way home, my seat was dry before i drove the car again a couple of months later.
Rob
There is no top for the race car (see picture above) Its a chopped windshield frame, no rear window, old FP road racer that is coming back to life with a 3.0L /6
Garold,
The coolest thing I can think of would be to install snaps and have a boat top shop make a Sunbrella top for it that would hold while being trailered. Might mean snaps every 6 inches instead of 12.
If the seat is your only concern , how about putting heavyduty trash bags over it and tie it down with bungies, that should keep it pretty dry. Just my $.02 .
Jaxdream
No cover...just go fer it. I do try to leave it home when it's gonna rain.
It's a race car not a CW queen.
Get a Perry Umbrella cover, then have Millie sew some snap-straps that would go around the roll.bar.
T.C.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)