Anyone know? I need to replace some....and I am terrible at bolt sizing....
I think stock is 8mm x 52mm but there are repair studs 9mm x ... and 10mm x .... step studs I think they're called. A source for the step studs is Raby's site.
I shouldn't have to re tap them, threads are good...just typical rusted studs. So a 8 x 1.25 x 52 should do correct?
I forget if they are 1.25 or 1.5. Hmmm.....
They are definitely 1.25 from the factory. YMMV based on your PO.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)