I am going to put a front oil cooler in my 73 2.0/4 that i use for autocross and DE . Has anyone used the Mocal oil sandwhich plate with the thermostat in it? and what size lines should i run ?
I have an RX7 cooler or should i get something else?
I run one and use -10 lines with it.
Ed
I run one and ran -12 lines. Make sure you use the aluminum ends on your lines so the expansion is the same rate. It is tough to get these things sealed up right.
Chris
Ditto...I used -10 aeroquip rubber lines w/ alum fittings...pics of my install here:
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=7103&hl=
I basically copied Ed's setup from a while back...
Good luck,
Tony
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)