I just got some nice oem fogs from Michael, and went thru my Haynes last night, but cannot figuer out where the mounting stud goes on the bumper backing?
any one have a pic or sketch of the backside of the bumper?????
TIA
Gary
Maybe I can get you an image later today if no one posts prior.
that'd be great, thanks Ron
Gary
If your car didn't come with fogs the mounting brackets on the inside of the bumper aren't there. I installed fogs on my '75 and had to fabricate some L-brackets with slots in them. There's a diagram in a topic on this board. Just have to find it...
Not here. Over here: http://forums.pelicanparts.com/showthread.php?t=74300&highlight=bracket
Thanks, Zonedoubt, I feel a little more comfortable, with that info.
So I need to fab an L bracket, slot it appropriately and mount to the the bumper backing??I can do this.
Appreciate the input, you re at the top of "My Hero" list toda
Gary
Didn't all the '75s have provision to mount the lights ? You's have to remove the bumper to see.
Loosen the bumper shocks when you pull the bumper. It will make alignment of the main bolts easier when you replace the bumper.Main bumper nuts are 19MM
I made mine out of plumbers tape. But dont take the rubber off the bumper! It is a bitch to get back on. (ask me how i know)
Used rubbers always were hard to get back on especially after they were washed.
Morning, guys
Mine looked like the brackets had been removed. after cutting the rectangle thru the rubber, and placing the lightsthere is a quarter round notch right where the bracket should be.
fabed up brackets last night ,
thanks for all the help
Gary
Oh, BTW, I know it isn't easy, but if you don't remove the rubber cover,
you don't see ALL the rust inside where the "tits" mount onto the metal bumper.
I am adding bunch o' wire brush and Por 15 to the reassembly list.
Gary
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)