I could use some pics of drop links setups. The Tarret adjustable drop links I bought don't come with hardware. Seems like I'll need some for the Utabs on the A-arm. Thanks in advance
Attached image(s)
I can't get a good pic right now, if nobody's gotten one for ya by tomorrow morning I'll take one.
And another pic with the top bolt ...
Attached image(s)
Here is how the kit comes, where you need to mount the tab and installed
Thanks for the pics . Look slike I have what I need then. Just seemed like the U-tabs would be to wide without some spacers between the drop links. Guess they will be fine. I have the bolts from my original. I was just mistaken thinking I needed more hardware. As always you guys rock
You need the spacers. Look at Andy's picture and you can see them and in the pile of nuts and bolts in my pictures. Without them the joints are restricted in movement
Probably direct from Tarrett, if you don't have a lathe. The step fits inside the heim joint. Whatever method you use, make sure the bolt is a snug fit through the heim and bracket or the bar will clunk a won't work well.
Jamie, in your first picture you have four like things right next to the drop links. Those are the spacers.
Oh LOL I'm a little off this morning. Good catch there Jon
Yes, that was a good catch. I assumed that was a generic picture since he said he didn't have any hardware. That's what I get for assuming.....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)