low profile air plenums for air intakes.
http://store.summitracing.com/egnsearch.asp?Ntt=air+plenum&N=700+4294925239+115+400068&Ntk=KeywordSearch
http://www.youtube.com/watch?v=nCRZ-BMejZs
that idle is driving me crazy - would someone pls push down on the gas peddle : )
With a hat like this, you could easily a AEM style ricer tube!
It would make for some nice, low profile systems.
"It would make for some nice, low profile systems."
Yup, it fits under the stock lids with no clearance problems at all
Paul
"Paul, were you able to use that firewall piece I sent you? :highjack:"
Eric,
It's just getting warm enough here in MN to go back into the garage so I haven't done any work yet. But yes, the panel is fine and will work for making the access hole through the firewall.
Thanks
Paul
Old 70's LT1 Corvette's had a hish rise intake manifold. They then had to use a drop base air cleaner. This gets the air cleaner top litterally at the topline of the carb. quite impressive really..
I'd expect it to work for a 914, just as it works for my dad's Vette.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)