i thought for sure the rubber motor mounts had gone bad - i jacked up the car and started the engine - and realized it was at least one rear one was bad - luckily i had two new 911 type laying around - installed them and engine idles with no bounce now : ) lucky for me as this is the limit of my mechanical abilities, well this and installing gas in the tank : ))
Attached thumbnail(s)
so, now you're ready for Hershey
next time use new bolts and nuts... good grief.
good eye - rusty nuts and bolts - busted : ))
grade 8 stainless would have been sweet ??
dang it : )
they of course were not there when i started the project or else - i PROBABLY -would have put them back on : ))
i'll have to put up a set at the hershey swap next week.
thanks brother andy
jim
I personally would not use stainless bolts on this but high tensile ones, I know it is not high stress but there you go stainless where there is little stress in volved.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)