I posted this in the Paddock too, but I'd like to throw it out to everyone.
I'm wondering if anyone would be interested in a fiberglass repro of the spoiler on the Wayne Baker IMSA GTU car. The original is made from sheet aluminum, so I would clean up the metal joints and get rid of the rivets, but the overall shape would be the same. The Gurney on the rear would be a separate piece.
I'm doing one for myself and one for a customer, but if there is any interest I could make more permanent tooling and pop 'em out.
A slightly smaller version without the Gurney or the side fences might be easier to live with on the street...
Any thoughts/suggestions appreciated!
Attached thumbnail(s)
Naw, I all ready got one
[attachmentid=175795]
Attached thumbnail(s)
REAR Jim.... Rear spoiler...
(I've got one of thse too...)
Attached image(s)
100 inches total.....50 sq in per side is the way I read the rule. Re-reading it ....verboten in XP but legal in EM.
The shape of the spoiler doesn't matter (as long as it doesn't act like a wing), the height above the body work is the determining factor.
Wings are legal in XP.....go figure....and you can have end plates..200 sq in...total area.
Hay, I didn't write this shit.
It's still a good lookin' spoiler.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)