I just picked up a 72 914 and i am trying to get the engine grill off to straighten and paint. I cant figure out how to get any of the clips off that hold the grill and the emblems on. It seems like im going to have to destroy all these clips to get this assembly appart. Is there a special tool i can pick up for removing these or do i just crush them with some plyers. Hopefull someone out there knows some tricks. Thanks
Try to grab them with needle nose or regular plyers and "unscrew" them like they were nuts. Pull at the same time.....
You can get new clips from Morph. Check the Vendors section.
You could also try something like a panel or tack puller. Be careful not to break the stud on the emblem.
Lets get this straight.
I think what he wants to do is lift of the whole grill section with the letters intact.
To put on another car.
Will the grill come out of the engine lid?
Yes the grill will come out of the frame. Same clips as emblems. Same removal procedure......
Use the force luke
with regular pliers, just squeeze the keepers in half and again @90*. they will fall off. or spend as long as it takes doing a frustrating task and still ruining the keepers. a few are very hard to get to.
k
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)