cv joint options - where to buy?
There is a thread on the forum, but I picked mine up from PMB Performance.
http://www.pmbperformance.com/page/page/4055868.htm
http://www.914world.com/bbs2/index.php?showtopic=96430&hl=
That's the thread I started about this about a week ago. I'm looking at doing something similar to the PMB, but actually machining the VW CV myself (since I have less than 0 money right now).
Bought mine from PBM. Fit great. On mine, I did notice that the holes that were drilled for the pins could allow air or water to enter the CV. I just plugged the ends of the holes with Silicone seal. Have about 9,000 miles on them so far. JoeO
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)