I was thinking the first thing to do was reinstall the wiring harness. For you folks who have done a total restoration, is that the place to start?
no....I think you should paint some more.
Rich
The suspension is what I installed first, then fuel lines and brake lines on my car. I'm helping a friend of mine build a 67 Chevelle, we did the chassis and suspension first, now getting ready install the body and start the wiring.
Attached image(s)
Eric has the suspension, so I'm taking the next step.
And no I didn't paint the wire yet. Did clean so paint off of it fron a PO.
Aside from the rear brake line, which I would install first, then maybe the fuel lines, then the wiring harness.
Basically do the tunnel
Rich
Flip the car on its side...its alot easier to reach that way.
Rich
reassembly is the reverse of removal
Start by feeding the wiring harness from the engine bay into the tunnel -
I think Sir Andy has an entire thread on this -
The brake lines and fuel lines can be done before or after -
And, if you still have the car on the rotisere (sp), flip it on its side as previously suggested.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)