Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ brake master cylinder r/r
Posted by: bel Jul 22 2009, 11:44 AM
I purchased a 19mm brake master cylinder and it is slightly different than the m/c in my car (also a 19mm) The one in the car has 2 electrical wires attached to it. the new m/c has a singl post to connect a wire to it.
Any ideas on how to properly wire this new m/c. The old one had a solid wall to seperate the 2 electrical posts. The new one has a rubber button type thing in the center but only one electrical post.
The car has 2 wires but I don't know what to connect. all the photos of m/c replacements show the hood over the wiring so i can't see what their wiring looks like.
Thanks for any help
Posted by: dr914@autoatlanta.com Jul 22 2009, 12:07 PM
QUOTE(bel @ Jul 22 2009, 10:44 AM) 
I purchased a 19mm brake master cylinder and it is slightly different than the m/c in my car (also a 19mm) The one in the car has 2 electrical wires attached to it. the new m/c has a singl post to connect a wire to it.
Any ideas on how to properly wire this new m/c. The old one had a solid wall to seperate the 2 electrical posts. The new one has a rubber button type thing in the center but only one electrical post.
The car has 2 wires but I don't know what to connect. all the photos of m/c replacements show the hood over the wiring so i can't see what their wiring looks like.
Thanks for any help
just do not connect the brown ground wire. the switch grounds through the master cylinder
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)