I recall seeing an article on this in the past but cannot locate it. Any help?
Which pump?
30mm Schadek
Measure the distance between the gear tops and the top of the aluminum housing (where the cover sits). If you don't get 0.005" (IIRC) then take the gears out, find a thick piece of glass and get some sandpaper. The glass will give you a true flat surface, put the sandpaper down and sand in a circular motion to remove material from the aluminum housing (where the cover sit). Check often since it's easier to remove material than replace it.
Thanks! That's what I remember reading (except for the .005). -Mike
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)