Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ relay board input/output plugs
Posted by: Scott Schroeder Aug 21 2009, 05:14 PM
Hi all -
I am planning my wiring for the conversion. I will be pulling the relay board. Does anyone make a plug that goes into the factory -4 main harness plug (I dont know if it would be a male of female). I would like to keep the main harness intact, and simply build the other side with the matching wire colors and plug the sucker in
- Thanks!
....
Posted by: SirAndy Aug 21 2009, 05:27 PM
QUOTE(Scott Schroeder @ Aug 21 2009, 03:14 PM) 
Hi all -
I am planning my wiring for the conversion. I will be pulling the relay board. Does anyone make a plug that goes into the factory -4 main harness plug (I dont know if it would be a male of female). I would like to keep the main harness intact, and simply build the other side with the matching wire colors and plug the sucker in
My engine conversion harness from Patrick Motorsports had a connector on it that perfectly fit on the stock /4 connector that usually pugs into the relay board.
So yes, they are out there ...
Andy
Posted by: Scott Schroeder Aug 21 2009, 05:44 PM
THANKS!!!!!!!!!!
Posted by: ClayPerrine Aug 21 2009, 05:54 PM
The 14 pin male connector is the one you need to fit the 14 pin female connector for the relay board. You can get them from Porsche direct, or do what I did, and call Dennis at Zims. They keep them in stock.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)