Printable Version of Topic

Click here to view this topic in its original format

914World.com _ FS/WANTED: 914 Cars and Rollers _ FS: 1975 roller, L80E, front sway, Koni's

Posted by: B2524 Apr 22 2012, 06:15 PM

Up for sale is a 75, paint code L80E light Ivory.
selling as a roller with the following parts removed:
Engine and computer.
Trans and linkage.
Dash has one crack and will be $200 extra.
Top will not be the one in the photos, will be a stock roof.

Steering wheel will be a stock one.
seats will be a nice pair of stock black seats.
no radio
has an air dam.
has Koni's that were installed just before the engine dropped a valve over ten years ago.
has a front sway, no rear.
a tree fell on the hood so I swapped hoods, the dented front fender happened when the motor work was done.
there is a small dent in the right door down low and in the right rear fender.
there is no console.


i need to clean the interior before i can take pictures, it's bad.

figure on replacing the door panels, carpets and some of the other interior stuff.

the rear truck holds water ( i need to drill some holes to drain it...)

i've only looked under the left side and it looks great. i need to move the car so i can jack it up and see under the right side.

asking $2k, it is not in the system so it will come with a bill of sale.
located south of San Jose.




Attached image(s)
Attached Image Attached Image Attached Image Attached Image

Posted by: B2524 Apr 22 2012, 06:20 PM

the bra is only on to hold the hood down. i didn't have time to adjust the latch so i removed it. i didn't want the hood to get stuck closed.
i'll post pictures of the car without the bra when i have time to install and adjust the latch.
kd

Posted by: 396 Apr 22 2012, 11:30 PM

How about the 'blue' one in the back ground?

Posted by: B2524 Apr 23 2012, 08:31 AM

the blue car is not for sale at the moment.

i have a 1.7 that runs although 2 cylinders are low on compression and i have a spare side shifter that i can offer if someone is looking to complete the car. i would throw them in with the car but i would not try to get the car running.

this will need a complete brake system rebuild, fuel system flush and so forth.

Posted by: tadink Apr 30 2012, 10:01 PM

and the rust? what about the rust?

td

Posted by: B2524 May 3 2012, 09:02 AM

hell hole isn't too bad, needs a patch.
will get pictures as soon as i pull the motor and tranny.
too many irons in the fire.

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)