SOLD and transported to new home
1971 4cylinder roller for sale. Too many projects and not enough time or space.
Good hell hole, battery box replaced.
Minor rust repair done in trunk and front bumper mount area. Exterior bodywork done and shot in DP90 primer and is ready to shoot.
Underside of car should be blasted to remove minor surface rust and re-painted/undercoated. There are no rust thru, just a few places that need attention.
Take a look at the photos, A good honest solid car.
Located in the Near Detroit Suburbs
Has rear trailing arms, struts. Front and rear glass, doors are bare shells.
Car has been completely stripped, so you will need to put brake/fuel lines, vent hoses, Have some interior parts, wipers, wiring harness, switches, tail and turn lights. Early shifter and rods. Couple of boxes of misc parts. But not enough to reassemble the car. Includes all glass, windows.
No Driveline, as in no engine, trans, tinwork,
PM for more info or more detailed photos.
$1400 offer SOLD
Attached thumbnail(s)
More photos
Back up buyer back out
Attached image(s)
Man, if you've ever fixed one with lots of rust you'd know you would be miles ahead to start with one like this.Would save a lot of hair pulling.
Wish this was on the west coast, I would love to swap all my v8 stuff to this!
Had a couple of lookers, still available
Few more lookers, still available
Gary is busy tonight so I'll post a picture and tell everyone that Kyle has bought the roller. Tom stopped by as well so we got to see pics in detail of his silver 914 restoration that was at the Parade.
Here it is:
Left to right:
Kyle, Gary, Tom and me.
Paul
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)