Yes over 2 years to make the much needed alternative at a reasonable price.
Attached thumbnail(s)
Thank you for making them Mark, but as you probably know, URO has made these now for quite a few years and they can easily be retailed for 75 each, and you could have made money on them, so why did you spend the money on tooling? We have not had a problem with them (very very small failure rate) and they include the new brake switch as well
Why?
Well, George the URO I had failed in about 10 pumps. It was an internal failure. That and I made an easier to install version.
I did a write up on it that and a basic FU to URO. I'm dropping down on them in other markets too. Pretty easy when they have the reputation they do.
What is the price on the 19mm master cylinder?
MarkKaiser
kaiserm34@yahoo.com
248 766-2159
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)