Please see http://engmanparts.com for details
Included are two circular plates and two oblong plates and two bolt on plates and mounting hardware. No drilling is required - these bolt right in.
Here is a http://www.914world.com/bbs2/index.php?act=ST&f=2&t=44389&st=0 of the product.
PM or email me.
Attached image(s)
Revised...
M
What about the holes in the tin for the J-tubes in the engine compartment?
dont have one for those - but - they can be made. How many do you want?
M
How much for the block off plate in/on the engine tin ( one for each side)?
Please see both questions on post #9 in this thread regarding the block off plates:
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=44389&st=0#entry1345383
Thanks a bunch!
Figured it out! It was an M6 x 1.00 screw! Problem solved.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)