Posted by: gms Dec 4 2012, 10:46 AM
the first hole on the rear panel is 92 mm to the left of the tail light housing cutout.
(not the 914-6 VW Porsche badge)
Posted by: Pat Garvey Dec 5 2012, 07:36 PM
QUOTE(gms @ Dec 4 2012, 05:18 PM)
52 mm above panel rib
Good, useful stuff Glen!
Have any measurements for the "other" script?
Pat
Posted by: SirAndy Dec 5 2012, 11:52 PM
QUOTE(Pat Garvey @ Dec 5 2012, 05:36 PM)
Have any measurements for the "other" script?
I would proudly wear the 914-6-(VW)-Porsche script if i could get my hand on one (again).
The last one i had i cut up to make a 916 badge (kinda stupid, i know).
Oh, and FYI, the "Porsche" part of the 914-6 script fits perfectly into the (US) holes on the rear panel on a '74.
Random, but true.
Posted by: bcheney Dec 6 2012, 06:48 PM
QUOTE(SirAndy @ Dec 6 2012, 12:52 AM)
QUOTE(Pat Garvey @ Dec 5 2012, 05:36 PM)
Have any measurements for the "other" script?
I would proudly wear the 914-6-(VW)-Porsche script if i could get my hand on one (again).
The last one i had i cut up to make a 916 badge (kinda stupid, i know).
Oh, and FYI, the "Porsche" part of the 914-6 script fits perfectly into the (US) holes on the rear panel on a '74.
Random, but true.
I have a 6 conversion that was recently completed. Can you guys tell me what the mounting stud spacing is for either a 914-6 or a VW Porsche 914-6 badge is? My car is originally a 75 914 2.0 trying to figure out what my options are for a 6 rear badge. I thought about having a vinyl 914-6 badge made up....but I need an electronic file of the script.