Posted by: TonyA Aug 4 2017, 06:08 PM
What is the finish on the seat tilt adjuster? Is it chrome or just a mat finish steel.
Posted by: SKL1 Aug 4 2017, 08:43 PM
Definitely not chrome. Just steel with no paint I can see. It does discolor or get surface rust over time.
Posted by: 1970 Neun vierzehn Aug 5 2017, 11:45 AM
QUOTE(SKL1 @ Aug 4 2017, 06:43 PM)
Definitely not chrome. Just steel with no paint I can see. It does discolor or get surface rust over time.
see photo..........
Attached image(s)
Posted by: Tom_T Aug 5 2017, 12:50 PM
QUOTE(1970 Neun vierzehn @ Aug 5 2017, 10:45 AM)
QUOTE(SKL1 @ Aug 4 2017, 06:43 PM)
Definitely not chrome. Just steel with no paint I can see. It does discolor or get surface rust over time.
see photo..........
IIRC that's a flat silver zinc plate finish on it in the pic above.
If you're needing to refinish yours, then you can group other similar finish parts & take them to your local plater, or Bruce Stone/bdstone on here may have some which he's restored.
Tom
///////
Posted by: Cal Aug 6 2017, 08:16 AM
Matt finish.....here are close up photos from when I cleaned the interior of my low mileage '74 2.0L.
Tony, I noticed that you're located in Hilltown.....I live very near you. I sent you a PM.
Attached image(s)
Posted by: TonyA Aug 8 2017, 09:01 PM
QUOTE(Cal @ Aug 6 2017, 10:16 AM)
Matt finish.....here are close up photos from when I cleaned the interior of my low mileage '74 2.0L.
Tony, I noticed that you're located in Hilltown.....I live very near you. I sent you a PM.
Thanks Cal yes I messaged you back at least tried to
Posted by: TonyA Aug 8 2017, 09:05 PM
Thanks for everyone's help
Posted by: dlkawashima Aug 10 2017, 03:28 AM
Are there replacement knobs available for the seat tilt adjuster?
Posted by: SKL1 Aug 10 2017, 08:35 PM
Try 914 rubber or Stoddard...
Posted by: Ross Aug 17 2017, 11:34 AM
Hi, where did you get the boot for your hand break? That looks good.
Posted by: 914Next Aug 20 2017, 11:13 AM
QUOTE(Ross @ Aug 17 2017, 01:34 PM)
Hi, where did you get the boot for your hand break? That looks good.