Printable Version of Topic
Click here to view this topic in its original format
914World.com _ Originality and History _ 914-6 rear emblem hole locations
Posted by: John Mar 12 2008, 09:17 PM
Could someone measure the hole locations for an original 914-6 emblem.
I need a starting point. I know center to center dimensions for the holes.
If I could get a height and a distance for one of the 3 holes, it would be a starting point.
Thanks.
Posted by: 914Sixer Mar 14 2008, 12:32 PM
Do you have a 914-6 emblem? Take it and press it into a piece of cardboard. You should be able to use those holes for your drilling pattern. Cut the cardboard down to size and use it to center it where you want it.
Posted by: 70Sixter Mar 15 2008, 10:57 AM
From the right tail lite to the rt edge of the 6 is 1 7/8" and from the lip below the 6 to the bottom of the 6 is 1 7/8". I can measure the hole, but the reference points are less clear
Sorry, accidental discharge. See next
Posted by: 70Sixter Mar 15 2008, 11:01 AM
From the left side of the right tail lite to the rt edge of the 6 is 1 7/8" and from the lip below the 6 to the bottom of the 6 is 1 7/8". I can measure the holes, but the reference points are less clear.
If you make the template 914Sixer suggested you should be good.
Posted by: John Mar 17 2008, 07:12 PM
From the left side of the right tail lite to the rt edge of the 6 is 1 7/8" and from the lip below the 6 to the bottom of the 6 is 1 7/8". I can measure the holes, but the reference points are less clear.
If you make the template 914Sixer suggested you should be good.
Thanks,
That should get me real close. I don't want to install it where it doesn't look right.
John
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)